Posted by Bruce from Can. on May 22, 2019 at 06:43:05 from (74.12.73.21):
In Reply to: Kubota for hay making posted by Ray Tractor on May 22, 2019 at 05:29:42:
I didn’t have any experience with Kubota tractors until 2014, and I bought two new Kubota tractors that year. A GX 135 M and a GX 100 M. So only real advice I can offer to you would be to be sure you buy a tractor big enough to meet your needs. I traded my GX 100 M after 18 months on a new M6 141. The 100 just wasn’t big enough for the work I wanted to do with it. The larger tractors tend to come with bigger tires, give better ride and floatation. I like a 100+hp tractor on my round baler, because we make mostly wet silage bales. Silage bales can get heavy and take more power, and if you have hills in your hay fields, extra power makes baling going up the hill easier on the tractor, and the heavier tractor has better control going down, and a better chance of stopping to eject a finished bale on a hill.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.