Posted by 44 massey on May 06, 2019 at 18:51:16 from (108.160.58.120):
In Reply to: Massey harris 101super posted by Stephen Hawk JR on May 06, 2019 at 09:49:21:
I had a pair on a 101 MH junior where the hub was the inner wheel that the rim bolted to, sounds something like u may have!! I struggled with them for months!! I even got long drill bits and went in and drilled out the key ways!! If your wheel center has holes for weights or if it just a hub like 44s (and most all models used) use redibolt and a heavy piece of iron across the end of the axel and run redibolt they thru the iron and hub and tighten, making it a puller! I did this and left pressure on it CONSTANTLY, still took considerably a lot of pounding with a hammer before they even began to move!! Didn�t think they were ever going to move but eventually they did!!! Good Luck! Takes a lot of patience!!!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
