(800) 853-2651
SHOP NOW

Massey harris 101super

S

Stephen Hawk JR

New User

I have a 1940 Massey harris 101super that i want to narrow but i cant move the wheel hubs i have removed the ring of wire keeping it from moving. But i cant move it tried to spread the hub and soak it in
penetrating oil but no luck i have hit it with a 10lb sledge hammer and it wont move any suggestion?]
 
If it's like the Deere ones, you can try taking the hub clamps off and then driving it around a bunch. I'm not 100% familiar with that clamp setup.
 
I had a pair on a 101 MH junior where the hub was the inner wheel that the rim bolted to, sounds something like u may have!! I struggled with them for months!! I even got long drill bits and went in and drilled out the key ways!! If your wheel center has holes for weights or if it just a hub like 44s (and most all models used) use redibolt and a heavy piece of iron across the end of the axel and run redibolt they thru the iron and hub and tighten, making it a puller! I did this and left pressure on it CONSTANTLY, still took considerably a lot of pounding with a hammer before they even began to move!! Didn?t think they were ever going to move but eventually they did!!! Good Luck! Takes a lot of patience!!!
 
You must log in or register to reply here.

Similar threads

H
Massey harris pacer snow plow mount
Replies
8
Views
508
Harris101
H
R
1943 Massey Harris manure spreaer
Replies
6
Views
485
rick n ohio
R
S
Is it worth it? Massey-Harris Pacer Facebook Find
Replies
8
Views
497
ptfarmer
ptfarmer
R
Massey Harris #11 manure spreader
Replies
3
Views
388
Texasmark
T
M
Massey Harris Colt Issues
2
Replies
28
Views
675
rustred
rustred
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top