Posted by 2510Paul on May 05, 2019 at 10:44:31 from (184.97.41.9):
Can someone explain to me how the rollover cylinder and control valve with check valve work with the tractors SCV. I ran my JD 4250 with Case-IH Roll-Over Plow yesterday, pictures to come, but the plow tends to roll out of position at the stop over time. I am thinking something is leading back. I guess it could be the SCV but it does not do that with my JD 4200 Roll-Over Plow.
The Case-IH 145 rollover Plow has a valve block tightly coupled to the cylinder (15). I see in the parts list it has a check valve in it (16, not in picture). So, I am wondering if that check valve could be leaking. I would like to understand better how that system works.
Rolling the plow over does not work like the Owners Manual says it should. I roll it and it bounces back and forth when it hits the end the the cylinder stroke. I just have to time my moving the lever with the bounce to get it to complete the stroke.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
