I am thinking they are pushing the wire a little to hard. Seems they got along ways yet to go on the project. Alot of stuff yet to assemble. Seems they are running behind on the dead line. I am getting concerned and nervous about how this turns out and being done on time.
They should be painting and test running by now I would think. It appears they don't have the cab and alot of components on yet. You know, this is a massive project. One large enough, you know there's going to be some bugs to work out once complete. That's what they should be doing now if running on schedule. The fact that steam crew working overtime, and Ed Dickens posting very few updates, tells me they running way behind. If running ahead of schedule, Ed would certainly be posting more updates. The oil convertion alone is in question, as to wether it will power itself without coal. Having flame in firebox is one thing. Creating enough steam to power itself to mobility is another. Having 200 lbs of steam sitting still is one thing, maintaining that pressure in motion is another. Iam just hoping this project pans out, and don't backfire on them for completion date. Otherwise, it may not power itself to spike anniversary, or bugs may have to be worked out after. I am crossing my fingers at this point, and hoping things work out. Hoping spike anniversary don't end up being the first test run for this beast. Just my 2 cents and concerns.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
