|
Tractor Talk Discussion Board |
Re: Re: Re: Re: John Deer M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Robert in W. Mi. on October 19, 2001 at 15:12:06 from (204.157.29.36):
In Reply to: Re: Re: Re: John Deer M posted by Bus Driver on October 18, 2001 at 18:39:50:
Answer:
No insult intended, just a FACT!
Over and over, people answer questions, and give out wrong information. A lot of times they even admit they really don't know.
If you don't know, why lead some one in the wrong direction with wrong information????
Saying a M has a 3 point, is an important piece of MIS-information.
Question: What good is the wrong information?????
BTW, my information says the 40 used better rod/main berring material than what was used in the M, and that the 40 lower end held up better.
Robert
Follow Ups:
Home
| Forums
Today's Featured Article -
Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
