Posted by Steve@Advance on March 26, 2019 at 04:48:00 from (24.182.105.179):
In Reply to: Today's Funny posted by Jon f mn on March 26, 2019 at 02:56:07:
A few years ago I was at work on a Saturday, by myself installing some air line.
I had a ladder leaned against the wall, on a greasy floor...
The ladder slid out, I had no choice but to ride it down.
When it went down, it went under a heavy steel work bench. I felt the corner of the bench hit me in the back as I went down and under. After assessing the damage, and realizing I had escaped with minor injuries, I went back to work.
That night when I got home and took my work clothes off, I noticed an inch long gouge out of the back center of my leather belt.
The belt had caught the corner of the table and saved me some very serious injury! An inch lower or higher and who knows what would have happened, especially being there by myself, the doors locked!
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Tinker�s Guide to Manifold Repairs - by Curtis Von Fange. A common characteristic of keeping older equipment is that some parts to make repairs can be extremely difficult to locate. For example, finding a replacement for a cracked intake or exhaust manifold on a unique tractor or odd brand can be a frustrating and downright impossible mission. So, what is an alternative solution to scraping out that �one of a kind� piece of history? First, decide if you are one to try a repair yourself or have someone else do it. If you are uncomfortable about
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
