Posted by Steve@Advance on March 08, 2019 at 14:49:06 from (66.169.147.211):
In Reply to: Paving Driveway posted by nrowles on March 08, 2019 at 12:13:47:
You say you trust your paver.
If you really do know and trust him, that's half the battle!
Around here, paving contractors are among the most corrupt and dishonest of them all!
Very common for them to lead off with a lie, "I've got left over asphalt, and I can make you a deal today..."
I would get bids from more than one contractor, and check their credentials with the BBB. If they don't have a brick and mortar business yard, RUN! No way to chase one down that only works out of his truck.
Part of making the decision would also include seeing some of his past work, not from the last few weeks, but look at something 10 years old. Also talk to the home owner.
You can also do some of your own research, look around the neighborhood, stop and ask who did their work and if they were happy with the job.
You live in a totally different temperature climate than I do. Asphalt is not a viable option here. It melts and ruts out, the sun bakes the solvent out, it turns to cracked open mess in a few years.
Some damage is from the sun, freezing, tree roots, but mostly because of contractors not doing what they say they will do. Somehow paying for 2 inches only gets you 1/2 inch!
I would also get bids on concrete. Here, a good concrete job will last a lifetime, but we don't have the deep freeze cycles you have.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.