I believe that the high dollar equipment is more precise as far as location and the specs state that it also gives a depth reading which is within 10% accurate. Knowing the approximate depth is an advantage that would pay the cost of the instrumentation in a few uses. I did not believe that the brass rod method of locating pipes worked until I had clogged septic field years ago. I called an experienced plumber who was able to find the distribution box and all of the laterals using ell shaped brass rods. I tried using the rods and they deflected at the same locations for me as they did for him. I put zero credibility on any mind over matter theory. However I and about half of the other posters have been convinced through personal experience that the brass or copper rod method works to locate underground pipes. If something works for my purposes, I will continue to use that technology or method. Note that I stated that the brass rod method "could be"a more crude version of the high dollar technology. I believe that There is a physics principle behind the brass rod locating method. I certainly respect the opinion of those who do not believe that the method works. This subject will never be resolved on an internet forum. It is interesting that the method continues to be widely practiced if it is a consistent failure.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Clutch Overhaul Tips - by Greg Sheppard. I got my 1964 Oliver Model 550 (serial 141-139-519) second-hand and used it for several years before the clutch began to slip. After taking up the pedal linkage several times I saw it was going to take more than that. The engine had been leaking oil at the rear seal and I suspected
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
