Posted by wsmm on February 04, 2019 at 05:50:43 from (174.230.21.112):
My plow truck has decided not to run! Turning the ignition on the fuel pump does not run. Going to the run position and holding it for awhile the fuel pump still does not run. Squirting starting fluid into the throttle body the truck starts and runs until the starting fluid is used up. Tested the fuel pump relay and the fuel pump relay socket as follows:
Just got done testing my fuel pump relay off of the truck using a multi-meter and a 9 volt battery. It works fine, so I think I have a problem in the wiring or some other sensor or switch. I tested the fuel pump connector with the key on and the key off with a power probe and got the following results, Key Off socket A 12 v pos Socket C open, Socket F open, socket E ground, socket D Ground. Key ON socket A 12 v pos, socket C open, socket F, E, D ground socket diagram __ ____ __ F E D ___ ___ A C
Is it possible and okay to run power to the ADL , then start and run the plow truck that way. I know I'm passing the low or no oil pressure safety that way but need to have the truck running to plow with.
Also does anyone have any idea of what to check next, I'm about of ideas.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
