|
Tractor Talk Discussion Board |
Re: good tractors for amputee
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JWC on September 04, 2001 at 19:43:56 from (130.74.184.124):
In Reply to: good tractors for amputee posted by sara on September 04, 2001 at 12:37:39:
Sara, In the mid to late seventies International Harvester made a 574 and 674. These tractors were almost identical except that the 574 had 52 pto HP and the 674 had 61 pto HP. At the time of their introduction they were one of the more advanced small tractors. All of the controls are mounted beside the driver. The hydraulic and pto control are on the right. The pto is fully independent and does not require clutching to engage or disengage it. The transmission has a high, low and reverse range controlled by the outside lever on the left and four gears which are synchronized and may be shifted while the tractor is in motion (clutch use required) controlled by a lever just adjacent to the seat. These tractors had fully hydrostatic steering and sweptback axles for a small turning radius. Since all the controls are mounted to the side it has a clear area where the gearshifts are on most tractors. It might be possible for you to make the transition from ground to seat in multiple steps. Both models have wide flat top fenders with very good handgrips. There is also a large mounting surface on the sides of the bell housing (clutch housing) that could easily accommodate a hydraulic lift that could elevate you and then swing you into the operating position. Other features include internal power disc brakes which require very little peddle travel and a rear cross mounted fuel tank which would provide an additional surface for you to brace against while getting positioned. These tractors in very good shape can be purchased between $4500 and $6000 in many areas.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|