|
Tractor Talk Discussion Board |
Re: Using left-handed drill bits - A QUESTION ????
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John in Ne. on September 03, 2001 at 10:15:56 from (209.74.225.169):
In Reply to: Using left-handed drill bits - A QUESTION ???? posted by Alberta Mike on September 03, 2001 at 07:26:20:
Mike, about 4 times in ten the left handed bits do the work for you, which is better than my experience with easy outs, a lot depends on how rusty it is, If you can drill all the way thru the stud and get some Kroil, wd40, or favorite solvent in the bottom to work its way up, and wait, might save you a bit. John in Ne.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Ford 3-Point Single Bottom Moldboard Plow with Coulter
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
