|
Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: Dodge trucks.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scott Green on September 03, 2001 at 09:10:44 from (209.130.131.39):
In Reply to: Re: Re: Re: Re: Dodge trucks. posted by Matt T. on September 03, 2001 at 07:48:47:
Yes , I agree. But many people don't check the box. That's only good if your ordering the truck. Even more people buy what is setting on the lot. Or they buy used with low milage. When I mentioned having no personal experience in my earlyer post , I was talking about since Dodge changed to the new body style. I remember one time in the early 70's , we were drawing loads of hay down into a gully , and back up the other side. Quite a steep road , but I didn't build it. Most of us had chevy trucks. One guy had a Dodge with 318 and auto transmission. Going down was OK , but the truck didn't have power enough to take the load of hay up the other side. We had to pull him up with the tractor. We busted on him about his Dodge truck back then. The suspention was also no where as good as the chevy. I've had my dodge trucks in the spring shop many times. They even told me that Dodge puts cheep spring steel in there leaf springs.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
