|
Tractor Talk Discussion Board |
Re: Dearborn Mower 14-15A sickle bar.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom-Pa on September 02, 2001 at 13:24:22 from (65.14.179.38):
In Reply to: Dearborn Mower 14-15A sickle bar. posted by Old Fart on September 01, 2001 at 17:38:37:
You will need more than just the axle bracket. You will need 2 ea 8" extentions for the vertical lift rods between the upper and lower lift arms, and a bracket that attaches below the toplink attach point. The 14-15 series and 14-16 series do not attach to the toplink itself.
nomenclature................P/N
toplink bracket.............141262
bracket & Ball assy.........141186
lift extentions.............142712 I made my lift extentions out of 3/8 pipe 'T' and 7" 3/8 pipe. the 'T's' are installed so centers are 8" apart and are 90 degrees from each other. I had to hunt around and finally found the two brackets at old farm equipment dealers on tractors and bought them as i had the mower(14-16) that used them..
If you want the manual and master parts book you can get them from the N-Newsletter archives..I have link below
Good luck
Tom-Pa
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Revival of a John Deere Combine - by The Red, John Fritz. For several years I had been driving by a farm house on the west side of Indianapolis that had a John Deere combine parked in high weeds in a lot behind the house. The gentleman no longer farmed because the entire area was developed with housing and light industry. I had stopped several times and knocked on the door but no one would answer. My curiosity was up and I wanted to contact the owner. I wanted to see what he planned to do with the combine.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
