|
Tractor Talk Discussion Board |
Re: Re: Loader removal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill on September 01, 2001 at 05:00:33 from (216.209.175.115):
In Reply to: Re: Loader removal posted by Jordan(OH) on September 01, 2001 at 04:27:05:
Jordan, I have a funny feeling that my setup is very similar to yours, only smaller (and with 2 pins instead of levers). Sounds to me like your method applies here too! I'll let you know, after I get a few minutes to try. Sounds like it would be a pretty darn good system, if it works like yours.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Grain Threshing in the Early 40's - by Pat Browning. The setting is rural Wisconsin, halfway between East Troy and Elkhorn, on Hodunk Road, our nation was at war, and I was 6, 7 and 8 years old. George was our "threshing neighbor." He was the one with the threshing machine, a JI Case on steel wheels, and he pulled it to our farm with a JI Case standard tractor also on steel. In those days, steel wheeled implements were common. The roads were general gravel, so the lugs cutting into them wasn't a problem. George would set up the thresher, s
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
