My opinion. You have just barely enough. Don't get mad....todays homes are power hogs. Turn everything off, turn the well on first. Bet that generator bogs down a little. If your house is all electric like range top waterheater etc. you don't have enough. Also if you have a high efficiency heater with natural gas the power must not bog down or drift frequency cause it can blow the control board. Not telling you to panic it is just you need to turn on only what you need and no more. Fridge, heater controls, water pump and that is about it. Equipment from even twenty years ago was very forgiving. Not so much todays stuff. My next door neighbor does HVAC. After a major power outage and people run a generator and have no idea and turn everything on at one time. The next several days he is running around changing power boards at several hundred $$$$$ a pop. Get a digital meter that measures frequency . You need to check your generators output and keep it there. You want as close to 60 cycles as possible. Also you want to run your generator on Hi-test gas. Beleave me on this. Let us see what others say about what you need. Most people I know that have recently purchased a generator went for a 9000 watt unit. Duel fuel is really a good idea cause you can run it on gasoline and you can keep several 20lb. Propane tanks in the back shed. One of those tanks is good for about 8 hours.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
