Posted by Mike M on October 31, 2018 at 13:02:57 from (24.140.3.210):
In Reply to: Re: Plowing posted by SVcummins on October 31, 2018 at 12:29:02:
There is a little depth stop on the 3 pt. controls to set for depth and along with the L & D lever in the proper position it should maintain close to where set at. I'd have to review the owners manual for settings. Gauge wheels were usually only needed on old tractors without load and draft control. According to JD literature their lower link system was to be among the best.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Running Beans in East Central Indiana - by The Red, John Fritz. Fall is my second favorite season behind the long days of summer. The calendar reads late September and it�s time to start running beans. This article is about my experiences helping my farm neighbor Ernie Swoveland, along with his grandsons Jeff and Craig Ring, with the soybean harvest in East Central Indiana for the 1999 season.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
