You can make ship lap edges using either machine. Another name for this joint is rabbeting (when done with the grain), or dadoing (when done cross-grain). (I always wondered about that. *lol*)
For tongue-and-groove, your best bet of the two machines is the table saw. However, it would be much faster and safer to make tongue-and-groove using a shaper or larger router; preferably a shaper.
As for how to make either of these joints, I'm not even going to try and explain it. First, been too long since "I've" done it. Second, .......it's just better if any instruction comes from people who do this work on a regular basis.
On top of it you're using antiquated machines. Yes, they're well made, but we have no way of knowing their current condition OR your own skill level.
There are ample videos on youtube that will show in great detail how to make either profile, though on newer machinery. I cannot recommend more highly than to check that out! Also, maybe look for a forum that specializes in the use of vintage woodworking machinery and maybe see if there is anyone in your area that could assist on getting the proper adjustments made for your machines. Also, these old machines weren't known for their amazing safety features.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Threshin Demonstration - by Michael Delaney. Introduction I bring you greetings from Prince Edward Island, Canada. We are Canada�s smallest province but big on farming. Maybe you�ve heard of us. Potatoes are our biggest crop. However, there is lots of mixed farming here also. I have a small mixed farm with 25-30 cattle. I make very good use of old machinery. I have a 135 MF Diesel, Farmall H and 1/3 share in an Allis B. I have complete lines of tillage and harvest equipment, and a saw gear etc. I have everything one would
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
