Posted by Netdad on October 14, 2018 at 14:04:57 from (98.66.41.49):
I have a problem that I can't figure out. I want to buy a manual for my tractor but I can't find out if it's an industrial tractor or another type. Below are the 3 sets of numbers from the right bell housing just above the starter.
D142C <--I can follow everything but the 14 as that doesn't match anything I have found. D= Force 4000, 14=?, 2=gas, 4=Independent 540, C= 8 Speed, (13 and 20 are on each side of 14. Help!) 4D29B <--4=1974, D=APRIL, 2=29th, B=Days C425551 <---C=Made in USA and 25551 is the serial number.
What is this tractor? It's painted blue as is the front end loader but the blue was painted over yellow so I take it the front end loader was industrial. I can't find a yellow spot rubbed through the blue however on the tractor.
Here's what's wild. The front end loader DOES have the same serial number sticker on it. Here's the specs. on the front end loader sticker:
Whew.....sorry to be so long but even though I feel the front end loader is from an industrial tractor, I'm not sure the tractor is industrial and I would sure like to get a manual for it.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
