Posted by in-too-deep on September 26, 2018 at 16:44:17 from (208.123.3.35):
Well, I dug down next to the old hydrant because I sure as heck knew I would find it easily with the least shovel work. Got out of the excavator and checked depth: 5ft. Ok, couple more swipes with the bucket and I better start poking with the shovel. Got down in the trench with my shovel and lovely Mrs. I-t-d standing by. I swear on God's Word I missed that 1" waterline by 3 inches. I was at the end of the excavator's reach, so if I had parked 4 inches closer to the hydrant, I would've hooked it and made a mess. It was only 6 feet deep instead of the usual 7 to 8.
Now, the best part. After marveling at my lucky miss, I poked a hole right in the stupid poly line with my shovel. A small geyser ensued as the line was still pressurized. I uttered a calm expletive and said "Honey, will you go pull the cover off the well pump controller, please." The irony was not lost on me. Miss the line with 10k lb mini excavator that I was still learning on, but then hit the line with a shovel.
Once all the pressure leaked out, the flow stopped. It must've been uphill and far enough away from the well that my high water level couldn't reach it. Installed my brass barb tee with double hose clamps and went on my merry way while the trench started to fill with groundwater that was seeping in.
Thank you for your responses on my original question and thanks for reading!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of David Brown Tractors - by Samuel Kennedy. I was born in 1950 and reared on my family�s 100 acre farm. It was a fairly typical Northern Ireland farm where the main enterprise was dairying but some pigs, poultry and sheep were also kept. Potatoes were grown for sale and oats were grown to be used for cattle and horse feeding. Up to about 1958 the dairy cows were fed hay with some turnips and after that grass silage was the main winter feed. That same year was the last in which flax was grown on the farm. Flax provided the fibre which w
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
