Posted by mt pockets on September 24, 2018 at 17:09:50 from (173.241.77.139):
In Reply to: Another auction find... posted by Dave H (MI) on September 24, 2018 at 13:40:58:
Mr. Dave, I don't reply to very many posts on here, because somebody else usually knows more than I do. However, in this case, I may be a tiny bit more knowledgeable than some . If that is a double acting cylinder, and it should be, you have to control the speed of travel by restricting the rate the discharge air leaves the cylinder. A flow control valve is the correct means of doing this. If this cylinder is pressure down and spring return, you will not be able to have the control that you need. You could put a flow control valve on the top side, it would slow the cylinder until it met resistance and then if pressure overcame resistance, It would become, as someone said, a hammer. To have complete and safe control of this machine, you would need a flow control valve on both ports of the cylinder. Flow control valves are free flow in one direction and controlled flow in the other. I hope this made sense. Steve, in Banner, Ms.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trailering Your Tractor - by Curtis Von Fange. One of the fun things of summer and fall are the parades and tractor shows that go on across America. Many owners of tractors travel long distances to attend these shows and they usually take their restored iron along with them. Safe trailering practices and inspections will ensure that the event is a fun one. A good habit to develop when using a trailer is to give that �quick look over� before taking it on a trip. Before hooking up to it check the tongue for proper operation. The latche
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
