Posted by FarmerBlair on September 04, 2018 at 14:05:40 from (165.230.224.196):
Hi,
I have a pole barn used as a garage with a dirt floor. It's fairly damp in general and plan to have a concrete floor installed soon. There is a problem in that some of the posts are rotted where they make ground contact. A few are 6x6", and some others are 4x4". I cut one of 6x6 posts about 3 ft up from the ground, pulled it out (it just fell over) and tried digging down around it to see if there was a footer. But between the rocky ground and some solid wood still in the ground, that was near impossible and I stopped after about a foot or so.
It occurred to me that I can have them pour the concrete up to the existing posts, then install new posts sitting on top of the concrete floor and mate the old with the new by sandwiching between a couple 2x12's. I'd lose a little inside space by adding a post to the interior side of the existing posts, but not enough to matter.
What I'm not sure about is while I'll regain strength on forces pushing down on the roof, but what about lateral forces? With the new posts just sitting on the concrete, there is no resistance to say, wind. Although there are cross-members near the roof, and it hasn't had much support that way anyway since before I bought the place last year, maybe this is the wrong way to do it.
Thinking I could try to use my 3pt posthole digger and try digging adjacent to the existing posts enough to set a pole in concrete, but maybe this just going overboard?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
