Posted by r8f1k on June 28, 2018 at 08:23:49 from (73.36.20.239):
In Reply to: Re: Oliver 550 Carb posted by Steve@Advance on June 28, 2018 at 08:03:55:
Ok, I should add a few points: 1) Compression on all the cylinders is 125+/- 5PSI. 2) Pulled the valve cover, everything nice and tight, no bent push rods. 3) Air cleaner is disconnected. 4) I pulled the carb off, soaked it, put a small parts kit in it. New float needle/seat/gaskets. 5) The old float looked like new, but was full of fuel. Had an old one that was in good shape, adjusted and put it in. 6) Fuel tank was nice and clean when I got it, flushed it anyway with solvent overnight in a power solvent tank, rinsed with alcohol. 7) Runs rich as hell.
I feel that the float needle is just letting fuel run past it, no matter what. I have an extra Marvel big bowl carb and parts that I could make work. Is that an avenue to explore rather than attempt to play with this one?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
