Posted by Steve@Advance on June 14, 2018 at 08:30:46 from (24.182.105.179):
In Reply to: 40:1 or 50:1 gas mix posted by old560 on June 14, 2018 at 07:10:19:
You want opinions, so here's mine...
I would run 50:1 premium synthetic oil. Be sure it is for air cooled engines.
I run it in everything, never had a problem. Chances are you are not running the weed wacker at full throttle and full load continuously. The max oil ratio is only needed under those conditions. Even then, if a chain saw can handle 50:1, and run full power, everything else should be a breeze!
What I have seen from running too much oil, and running cheap generic oil, it tends to carbon up the exhaust side of the piston and cylinder wall. The carbon gets in the ring land, sticks the ring, also the build up and crowds the piston over, loosing clearance to the point of having a seizure.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Threshin Demonstration - by Michael Delaney. Introduction I bring you greetings from Prince Edward Island, Canada. We are Canada�s smallest province but big on farming. Maybe you�ve heard of us. Potatoes are our biggest crop. However, there is lots of mixed farming here also. I have a small mixed farm with 25-30 cattle. I make very good use of old machinery. I have a 135 MF Diesel, Farmall H and 1/3 share in an Allis B. I have complete lines of tillage and harvest equipment, and a saw gear etc. I have everything one would
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
