Posted by Bob in SD on May 16, 2018 at 06:55:43 from (137.216.209.56):
I was going to title this "my drug problem", as in the tiller done drug me all over the garden w/out actually tilling much. I tried the highest (least deep) setting, it scratched and didn't yank me too much, but didn't till much either. Coming back over the same ground with the next setting it would grab and drag me across the garden. This has been tilled before, many years ago, but has gone to grass/sod lately.
Last week my local Runnings Farm and Fleet had a "middle buster" plow on sale, but it was recommended for lower HP tractors (I forget the number, and their online listings are down right now). I've got a 4-cylinder Ford 4000 which TractorData says is 40-ish drawbar HP and a gas 3020 which they say is 60-ish at the drawbar. Will I destroy the plow with too much HP if it doesn't catch on a big rock or something? Rocks are pretty rare in this area.
I also have a 7 foot box blade with 6 scarifiers/rippers. I can adjust them to 3-4 inches below the blade. Would dragging this through a few times and then tilling across that do anything? Any downside to that? I did that once before an convinced myself it helped, but I'm not so sure at this point.
In the past I've borrowed a friends cultivator and/or plow and the cultivator ripped it up pretty good. I may try to do that again. Is the cultivator (several metal leaf springs curving into the ground) the best option?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Ferguson TO-20 - by Staff. When the infamous "Handshake Agreement" between Henry Ford and Harry Ferguson fell by the wayside (that's a story in itself), Harry Ferguson quickly set up manufacturing plants for a United States version of his English TE-20. The TO-20 was relatively the same as the TE-20 except utilized some different casting materials and had a US-style electrical system. The TO-20 was a dead ringer for the Ford 9N and 2N models and they say that Ferguson did this on purpose when the Handshake Agreement wen
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
