Quoting Removed, click Modern View to see NH i'm having a hard time buying that story, I have had dozens of pumps rebuilt off dozers, tractors, trucks, loaders over the years. a good reputable hydraulic shop ( I use P.S.I.hydraulics) will have no problem rebuilding that pump. IF your old pump has serious issues, has been damaged, had a lot of metal go though it, etc they will call you and have you come in and look at it and they will recommend you get a new or rebuilt pump and SHOW you why. the dealers story you where told I have heard before, and that story is to get into your wallet for the $4 to $7k instead of $1500. for a proper rebuild. NH I had my yanmar B-6 excavator into P.S.I. last winter for a pump rebuild, and replaced most of the control valves (9 out of 13) and about 6 or 8 hyd hoses and the bill was under $8k.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
