Posted by jeffcat on April 11, 2018 at 16:17:10 from (50.207.7.236):
In Reply to: LED lamp standards? posted by Dan in North Houston on April 11, 2018 at 14:49:33:
Dan, go over to tractor off topic. Go to page 2 and look at Lawn Tractor Bright LED. I posted it the other day. Shows you what can be accomplished with LED bulbs. What You need to do. Take the light on your tractor apart and see what the bulb # is. That is where you need to start. If the bulb goes into the BACK of the fixture you need a projector type bulb. That is what I installed in all of my lawn / Garden tractors. If you look at the picture carefully you can see the same light pattern on the back of the house with both bulbs. Many old school tractors take 1156 12volt or the 6 volt equivalent of. You can get "sealed" beam look alike bulbs also. Go on Ebay and type in LED car bulbs. There are hundreds of types. Just a tip. If you need one of the aforementioned projector bulbs make sure you look for the Samsung makers lable in the listing. Much brighter bulb. I also put a tiny dab of Silicon grease on the bottom of the led before install. Keeps corrosion away. Be brave this will not take you too long and as you can see in the pictures it is well worth it. You can also look on U'tube at some of the videos. There are hundreds that cover almost anything you can think of.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
