Posted by docmirror on February 27, 2018 at 10:50:26 from (107.213.165.255):
In Reply to: Tankless waterheater? posted by Jon f mn on February 26, 2018 at 18:28:35:
FYI - The EZ Tankless 202 system relies on 2 D cell batts for ignition. If you have gas, and water pressure, you have hot water. Or, one could opt for the big unit, providing 165k BTUs/hr. That will heat 50F incoming water to over 100F at 5GPM, which is a lot of water. But - you need AC to ignite it.
For folks who travel the world, the tank water heater is almost dead worldwide, except for parts of Mexico in cities and the US. Of course, some large hotels, and other residential high density areas they still use tank heaters, but the majority of the world uses tankless now. At my cabin, I would never have a LP tank water heater. I'm sure my LP use would double over the tankless usage.
For those installations where the hot water flow declines enough to stop the heating, one trick I've found that helps is for the cold supply to feed in a long straight line pipe about 3-4', directly to the tankless cold water inlet, with the tap of the Tee fitting for the remaining cold water come off at 90deg fitting. I know it's a small thing, but water flow hydrodynamics can make a difference. In most cases, the tap for the feed to the tankless unit is a 90deg fitting, to a flex line, with reduced inside diameter, which restricts flow rapidly in the event the cold water tap is turned on to regulate.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Hitches For Your Old Tractor - by Chris Pratt. For this article, we are going to make the irrational and unlikely assumption that you purchased an older tractor that is in tip top shape and needs no immediate repairs other than an oil change and a good bath. To the newcomer planning to restore the machine, this means you have everything you need for the moment (something to sit in the shop and just look at for awhile while you read the books). To the newcomer that wants to get out and use the machine for field work, you may have already hit a major roadblock. That is the dreaded "proprietary hitch". With the exception of the
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
