Posted by rrlund on February 25, 2018 at 11:59:59 from (69.36.53.86):
The wife wanted to go to Midland today for a seed exchange. Heritage and heirloom seeds. It was about a 75 mile trip one way,and she didn't have anybody to go along,so I went with her. I had a good hunch going in what kind of people would be there. A bunch of old hippies,naturalists and the hemp wearing crowd. It didn't disappoint in that regard I'll tell you that. I made about one trip around the tables and that was enough elbows and little packets of seed for me,so I sat down on a bench near the entrance and just watched. I hadn't sat there very long when two older guys came through the door. The older one sat down beside of me to take a load off. I later found out he was 83. He started talking about milking cows,growing tomatoes and what not. I was just glad to have some company. I have to laugh right now because I don't know how I attract these guys,but he told me way more than I wanted to know about alternative farming methods,then politics and finally religion. Not finding fault with him,but there must be something about me that says "Open up and spill your soul".
We stopped in Mt Pleasant for dinner and the wife said "Well,did you learn anything from that old guy?". I said "Ya,I learned when somebody sits down next to you and starts talking,don't sit there for too long.". LOL
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
