Posted by Diymechanicmike on February 21, 2018 at 12:01:25 from (50.45.52.66):
In Reply to: Mf3165 posted by Diymechanicmike on February 17, 2018 at 15:12:07:
And if I were to do the 1:2gear box between pto and pump I could get the 1080rpm for the 40gpm and I under stand that doing that cuts my hp in half so say I have 45hp@540 rpm then that would put me at 22.5hp@1000rpm for the 40gpm rating. I see that I would be lacking 6.5 hp but wouldn't that still give me more power with hydraulics then if I were running it at 20gpm rating ? My crazy thought process tells me since I'm lacking 6.5 hp I'd be running at more like 30gpm ish correct me if my mind is crazy haha cuz I'm not a pro at this but do think outside the box. And possibly to far outta the box haha.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
