Posted by carvel minne farmer on February 20, 2018 at 20:00:40 from (207.228.78.229):
In Reply to: Mf3165 posted by Diymechanicmike on February 17, 2018 at 15:12:07:
mike I would go in and fall everything 3" and up, skid it out of the way to your firewood pile, and then go in with the brush saw. having a live pto is a huge bonus, what a live pto means mike is once it's engaged by your lever and the pto is turning, you can step on the clutch to slow down or stop and the pto will keep spinning at 540 rpm, my case 310b 30hp. do's not have a live pto and when I tried baling with it (not enough tractor for a baler) every time I stepped on the clutch to slow down for a big pile of hay both the tractor and baler would stop :evil: cleaned out a few plugs in the baler :lol: got a Minneapolis Moline m5 65hp with live pto and amplitorque tranny, a dream to bale with. as to the tractor speed in 1st low at 1.6 you should be ok with the live pto as you can ease the clutch and the saw will still be spinning at rated rpm.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
