Posted by ptfarmer on February 18, 2018 at 01:03:44 from (70.114.32.211):
In Reply to: Mf3165 posted by Diymechanicmike on February 17, 2018 at 15:12:07:
The specs on a 70" Bobcat forestry mulcher, operating weight 3000 lbs, the skid steer to run it 85 hp, and up. According to my brother who works on them, all the mulchers that are used on skid steers are pieces of junk, and are hard on skid steers. If you need one you are better off with either the big tire, or track type commercial forestry mulcher (you seen how big those are). With the weight of the mulcher, and all the things you need to make it work (gear box, pump, oil, oil tank, oil cooler, and the steel) that's a lot of weight by itself. I don't think the 3165 would be up to the task even if you got a mulcher narrower than 70".
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.