Posted by showcrop on January 09, 2018 at 04:48:30 from (75.68.37.174):
In Reply to: New Furnace Price posted by olgentdc on January 08, 2018 at 20:12:25:
I agree that you should shop some more. Labor and installer profit are a very big part. I installed a new boiler and boiler mate in my house three years ago, to the tune of 3K, but I was able to buy the boiler and the package for wholesale. It helped my retired buddy to keep his supply house account going. Two years later I got a boiler at church replaced, smaller job, for 11K. The new norm in weather is very broad swings which drives both heating and cooling way up. You are wise to get ready, yet you should hold off until contractors are looking for work. It is well known that excavation bids come in lowest in the spring when contractors are hungry and highest in the fall when they are flush and busy, and it is the same with the other trades. You should look into geothermal as well. If you have an area next to your house where you can have ditches excavated to lay the pipe in, geothermal can be much cheaper than an installation using wells, and geothermal operating costs can be very low in a system with excellent heat transfer.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
