Posted by Roger Tomfohrde on December 11, 2017 at 05:52:16 from (24.118.172.93):
In Reply to: Tire Safety posted by showcrop on December 11, 2017 at 04:11:53:
Another age old debate-- but I will state for a fact that I have two front wheel drive cars right now that have to have as good as or better rear tires than the front. Back end will( not possibly) swing out and go ahead of you on a slightly slippery road. It doesn't matter if it is straight or a curve, curves are worse. And yes the four wheel alignment is done often to make sure it is not an alignment problem. Bring your balder or hard tires up here and drive in the Twin Cities when conditions are moderately slippery and you will find out. Just saying as I have tested that theory a couple times and did not like it. Poor or hard tires here is dangerous and I have been lucky and not hit anything yet when out of control. The argument of slow down works but if you are the slowest one then you just became a problem that should not be on the road. Poor tires on the front of a front wheel drive will get around a lot better than a pickup with even a 1000 lbs in the back. I know that for a fact also and have done it many times. It is not the snow but ice that gets people into trouble.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
