Posted by Billy NY on November 05, 2017 at 05:52:06 from (74.76.4.60):
In Reply to: Cousin saw this posted by Ultradog MN on November 04, 2017 at 18:44:09:
We did have a pair of piebald deer frequenting the land here, about 8 years ago, for a few years prior. One was a doe that I saw for several years, followed by an 8pt buck of average size for around here. I let them be, and so did my neighbor, interesting to see in the wild, vs some dust collecting wall hanger that most would make out of them. We hunt for meat, not horns or fur. I get doe permit(s)when they are offered for this zone, and fill those tags. Large bucks are a rarity in this vicinity, though you will see signs of them, you rarely will see one except during rut. Doe taken here average 170lbs as is, (not field dressed). That is a consistent number, older ones are heavier, but the meat is not nearly as good. Bucks taken that looked decent, 150-160 lbs not field dressed. It's hard to judge in the field, there have been a few over the years at 200lbs, but it seems you will do just fine if you get doe tags and take one of those. Doe of the right age and size will yield the most amount of meat and as long as you don't take one with the teeth worn out, the meat is excellent. There are a lot of young ones around this year. Myself, neighboring landowner and my friends that hunt here try to avoid taking any of the younger bucks. I remember one year where a combined 5 young bucks were taken and there is no doubt it is part of the reason you don't see mature ones, that and they are smart and know how to avoid human contact. The below link is where a bunch of albino deer reside, I remember learning about this when we were responding to a proposal to build a large state prison there after the army depot closed down. Never realized there was so many in one place.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
