Posted by mite-help on October 31, 2017 at 17:39:14 from (172.242.6.245):
OK, I am working on ford 555E 4 cyl.--(taking over assembly where someone else left it)-yeah, I know)---Injector pump was removed for minor seal job on top cover-That parts good---installer before me marked the shaft & gear, said he maybe put it back-same spot. torqued the nut. he said pump shaft had place for key, but no keyway in gear. Ok, I see pump pin screw, so I'm gonna pin pump & set to flywheel marks. pull gear loose,turn pump thru & there is No place on pump shaft to pin to!! Turned pump thru several times--no slot or hole, visual, or feeling with icepick [the pin could not reach it if there was} what am I missing? or has my pump been designed for gear with keyway? the engine was running fine--Here is all the info I could find on pump----Lucas 1296 8920a671W 11194CSG Thank you for any help !
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
