Posted by Steve@Advance on October 16, 2017 at 13:10:13 from (24.182.105.179):
In Reply to: massey 50 posted by dennisj81 on October 16, 2017 at 12:05:19:
According to the IT manual, before serial # 500630, the relief is 1900-2300. After that serial # it is 2300-2800.
Says to check with the position control in the full up position, but I think you would need to chain the 3 point down, somewhere in the middle to get a true reading.
The relief pressure is set, non adjustable. There is a relief cartridge screwed into the pump.
You can check for internal leakage by removing the inspection covers, looking in with a flashlight (DON'T REACH IN THERE!) for oil swirling around down by the pump, which would indicate a leaking relief valve or blown oring on the stand pipe (that brings oil up to the cylinder), or oil spraying down from above, which would mean the upper oring on the stand pipe, or the cylinder seals leaking. Some seepage from the cylinder seals is normal.
Of course all this depends on the remotes being closed off.
That originally had 90 weight mineral oil, which is too thick for cold weather. Most run 15w40 engine oil.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Tinker�s Guide to Manifold Repairs - by Curtis Von Fange. A common characteristic of keeping older equipment is that some parts to make repairs can be extremely difficult to locate. For example, finding a replacement for a cracked intake or exhaust manifold on a unique tractor or odd brand can be a frustrating and downright impossible mission. So, what is an alternative solution to scraping out that �one of a kind� piece of history? First, decide if you are one to try a repair yourself or have someone else do it. If you are uncomfortable about
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
