Posted by slcullen on October 08, 2017 at 05:13:48 from (73.118.80.160):
I'm going to replace the hydraulic cylinder and piston in my 8N, side mount distributor. I've been looking at the manuals and on line sites about how to do it. I'm confortable with everything expect two things: the oil tube, and soaking the leather ring in water.
It seems wrong to soak it in water instead of gear oil. The amount of water getting into the gear oil is minuscule I'm sure, but maybe I'm being to cautious. Anyway, will it really make a difference?
As to the oil tube, I've seen absolutely nothing about the oil tube, only diagrams and pictures with an arrow pointing to it. I did see a posting about how to manufacture one and flare the ends to install it. Does the lift cover just come off and go back on with the oil tube in the right place and everything's fine? Must be something like that to cause no mention of it in the manual. Thanks, Spencer in Tallahassee
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
