I'm going to replace the hydraulic cylinder and piston in my 8N, side mount distributor. I've been looking at the manuals and on line sites about how to do it. I'm confortable with everything expect two things: the oil tube, and soaking the leather ring in water.
It seems wrong to soak it in water instead of gear oil. The amount of water getting into the gear oil is minuscule I'm sure, but maybe I'm being to cautious. Anyway, will it really make a difference?
As to the oil tube, I've seen absolutely nothing about the oil tube, only diagrams and pictures with an arrow pointing to it. I did see a posting about how to manufacture one and flare the ends to install it. Does the lift cover just come off and go back on with the oil tube in the right place and everything's fine? Must be something like that to cause no mention of it in the manual. Thanks, Spencer in Tallahassee
It seems wrong to soak it in water instead of gear oil. The amount of water getting into the gear oil is minuscule I'm sure, but maybe I'm being to cautious. Anyway, will it really make a difference?
As to the oil tube, I've seen absolutely nothing about the oil tube, only diagrams and pictures with an arrow pointing to it. I did see a posting about how to manufacture one and flare the ends to install it. Does the lift cover just come off and go back on with the oil tube in the right place and everything's fine? Must be something like that to cause no mention of it in the manual. Thanks, Spencer in Tallahassee