Posted by jude116057 on September 07, 2017 at 17:51:08 from (199.182.136.192):
Hey all looking to purchase my first square baler! Have no experience with John Deere but I think I am going to look at 327, any thoughts? I know to check side play in chains, sharp sprocket teeth and sloppy bearings after that it would just be using common sense. Would love to hear the pros and cons from yt land. Thanks in advance, Jude
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Self-Starting Tractor - McCormick 10-20 - by Francis J. Robinson. I remember it very clearly even though it was almost 50 years ago and I was only about seven years old. My Dad had purchased a new Ford-Ferguson tractor and basic set of implements when he started farming just about the beginning of W.W.II. It was considered a pretty nice outfit for their 70 acre central Indiana grain and livestock farm. Dad spent several years during the war testing aircraft engines at Allison Engineering in Indianapolis working seven days a week on a twelve hour night sh
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
