Posted by docmirror on August 08, 2017 at 00:11:40 from (107.213.165.255):
In Reply to: Welding on tractor posted by craig45 on August 06, 2017 at 17:19:24:
Quoting Removed, click Modern View to see
This. It's to protect the battery from rapid over-charge and explosion. Ground plane path is hard to determine, and it's not always a single path. If you are drawing 30V at 100A that's 3000 watts. Maybe 2500 watts is going direct from the frame to the ground cable, but another 500 watts is taking a different path back to the ground cable.
I would ground the + terminal of the batt to frame and if there is a large bulk connector to the ECU feeds, I would disconnect that as well. Also keep your ground on a clean spot near the weld.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harry Ferguson - The Man & The Machine Harry Ferguson was christened Henry George but every one called him Harry. Harry was born in a small Irish town called Growell in County Down about 16 miles from Belfast. Harry Ferguson led a varied and colorful childhood causing mischief where ever he could. He showed mechanical aptitude at a very early stage in life and showed no inclination towards
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
