Posted by DR. EVIL on August 01, 2017 at 07:38:12 from (174.197.3.183):
In Reply to: Silly question. posted by Stephen Newell on July 31, 2017 at 19:19:39:
BTO I worked for in HS and summers when in college had a Case 430 Industrial loader tractor. NOT A TRACTOR-LOADER-BACKHOE. Most work loading manure was on concrete but got on dirt often. Had about a 6 ft bucket, and a chunk of concrete about 2 ft x 3 ft x 3 ft, roughly 2500# hanging off the back 3 pt hitch. Plus ran tire chains year round. Even on wet concrete chains improved traction.
You need to set your tractor up similarly.
Couple years later I worked for Township road commissioner, used the Case 530 TLB lots, hoe hanging off the back really reduced slippage when loading dirt, Rock, etc. It would move fully loaded railroad tank cars full of road oil weighing over 100,000 pounds without slippage!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Ford 3-Point Single Bottom Moldboard Plow with Coulter
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
