Posted by wilson ind on June 23, 2017 at 07:08:20 from (12.201.39.102):
In Reply to: Crazy law suit posted by Jon f mn on June 22, 2017 at 12:52:37:
Had a friend in Montana large lumber mill. Asked one day as had read the mill just replaced band saws with new tougher thinner blades just how wide is actual cut . He laughed and replied that's a trade secret how much we can cheat on the finished product. They buy on full size board feet and can cut out at least 15 percent more. Also new blades require very little planning and sometimes boards will have saw marks on construction grade lumber. Not taking any sides, however law suit sure gives something to think about on the side of the original sawmill purchase.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: The Old Gold National Antique Tractor Show - by Cindy Ladage. Over the fourth of July weekend, the Illinois State Fairgrounds in Springfield, Illinois, was the site of the Old Gold National Antique Tractor Show. Tractors of all makes and models were displayed and separted into categories by their age. Deere, Oliver and even a Wards and Keck Gonerman were part of the crowd. A sea of red International Harvester's seemed to be the the model with the biggest showing. The crowd was decent for the scorching July heat. The opening day started o
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
