Posted by Bill VA on June 13, 2017 at 18:06:35 from (216.24.79.193):
In Reply to: MF 50 Value? Pictures posted by Bryce Frazier on June 13, 2017 at 17:20:44:
Bryce,
I've got a MF50 diesel and it's a fine tractor (though mine's got a flat tire and starter solenoid issues.... )
Someone correct me, but I believe the model you are looking at is a high crop version. IMHO this is very good as if you are haying, driving over windrows, etc, there's less to catch on the underside. Also note the foot rest pedestals. These make for a most comefortable ride on a long day in the field. Sort of like prop-upping your feet on a motorcycle.
Check to see if is a multipower tranny. Some like them, I prefer the standard tranny. There is a cotter key that sets in a hole at the bottom of the bell housing. When you start it, watch for tranny oil coming out. The fix is a split and seal replacement. I really enjoy my model 50, for us the high/low gear ranges are very good. The 3pt hitch should come up and not be jerky, it will leak down.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.