I went through about a 6 or 8 month stage when I was 19 or 20 where everything I touched fell apart. I either couldn't get anything right or it fell apart in my hands. It seemed like the harder I tried the worst things got. It was extremely frustrating for me and the guys I worked with. I was working for an excavating contractor at the time, thankfully he showed me some grace and didn't fire me. Fast forward 20 years or so and my oldest son is now helping me do things around the house. This kid is number 4 in his class but don't have a lick of common sense. I am not wired that way and it is really frustrating for me. I have showed him how to change the oil in my wife's van at least 6 or 8 times. Sent him out one day to do it on his own. Went out 30 minutes later and oil is not even drained yet. Ask him why? He said he couldn't find the 13mm wrench. Never dawned on him to get a 13mm socket. Stuff like that over and over again. Bad thing is I had the poor kid scared to death to do anything because I would yell at him. I had to back off and let him figure things out on his own. As long as he wasn't going to get hurt. Took me the better part of a year to get him to come out of that. He is 16 now and is getting pretty sharp on stuff. I just have to give him very clear directions or he will over analyze the task at hand.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
