Remove the coil and remove any rust between the coil and engine mount. With flywheel magnet not near coil, move coil .015" or more away from flywheel and tighten hold down screws. (is the coil ground wire under one of the screws?) Rotate the flywheel so magnet is in line with coil, place .008" feeler gauge in between and then loosen hold down screws allowing magnet to set the air gap. Remove feeler gauge by rotating the flywheel. Set points gap to .020" maximum opening and test for spark.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Revival of a John Deere Combine - by The Red, John Fritz. For several years I had been driving by a farm house on the west side of Indianapolis that had a John Deere combine parked in high weeds in a lot behind the house. The gentleman no longer farmed because the entire area was developed with housing and light industry. I had stopped several times and knocked on the door but no one would answer. My curiosity was up and I wanted to contact the owner. I wanted to see what he planned to do with the combine.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
