With so little water, far and away the biggest factor is the water retaining ability of the soil, yet you give no information on depth of loam. You need at least eight inches of moisture holding soil. The next thing is what material is under the loam? If it is sand you will need even more loam. If it is clay material, which is more common, you need less loam, because the clay keeps the moisture from penetrating. One day when I had borrowed a truck to haul material for a project, a friend who had been trying to grow a garden asked me to deliver a load of clay fill to him for his garden. He pushed the soil off, spread the clay, and put the soil back, now he can grow vegetables. Do the landscapers know what is under the surface? If not, $2,000 may not be enough to make it work. Post back with needed information. Another thought is: don't condemn your fall seeding yet. it could have caught well, then went dormant with the cold, and is lurking under the straw waiting for spring.[/quote:39fbbb602c]
I don't have clay. Other than that I don't know much other than my soil does not retain water and after a couple feet is EXTREME shale. Even the surface had quite a bit of shale and I had a guy come in with a rock hound.[/quote:39fbbb602c]
So should we take it to mean that you have?????inches of loam over ?????? inches of sand over the shale?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.