Posted by RN on January 20, 2017 at 10:59:43 from (205.213.104.118):
In Reply to: Re: Tractor Trivia posted by Trkr on January 18, 2017 at 17:11:46:
2 cylinder? Hart-Parr- the beginning of Oliver brand from designers Hart and Parr, developed at University of Wisconsin. Initial plan was to make them in Madison, Wisconsin but city council was putting up road blocks, wanting plant changes- about what current city council still does. Charles city, Iowa politicians said something like' we have a industrial park area, some electrical power available, water available and can have all the building permits signed a hour after you submit plans'. A small later model of Moline(?) - the 4 and 6 cylinder engines had 2 cylinder 'sub cylinder blocks' with sets of 2 cylinder heads, the 2 cylinder engine was a short utility and row crop for specialty crops, engine and other castings made on same molds as larger engines that basicaly made a crankcase and crankshaft that had multiple 2 cylinder heads on multiple 2 cylinder sleeves and water jackets bolted to the crankcase like some continental engines into 1950s. Some place in archives is couple pictures of off yellow 2 cylinder tractor about same power as IHC H or maybe C with mower, MM model number. RN
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
