Posted by fixerupper on January 14, 2017 at 16:48:07 from (100.42.83.79):
In Reply to: Dual loader questions posted by hayfarmer on January 14, 2017 at 15:14:29:
Cant help you with a manual. You might have to use your imagination and a tape measure to get it to fit. For 39 years I had a 325 on a 630 Deere that came off a 756. We shortened the beams going back to the axles by 6" and shortened the brace pipes that go down to the front of the tractor. It ran many thousands of hours set up like that. Those cylinders were almost always dripping but can be re-packed easily. Baum Hydraulics used to have seals but its been awhile ago since I last worked on it. There were several 560's with Dual's on them in my neck of the woods years ago. A local IH dealer sold them. The dealer is gone and so are most of the loaders.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
