Posted by docmirror on January 08, 2017 at 08:45:32 from (107.213.165.255):
In Reply to: Tractor Restoration posted by Ted in NE-OH on January 06, 2017 at 18:31:02:
My only comment is on step 2 with the wire wheel. All non engine, non trans parts can be better restored with an industrial sandblaster. I did the body/frame of a 1952 Studebaker coupe and the savings in time with a wire wheel was far better than the cost of the sand blasting. Also provides a better substrate to take primer than wire wheel finish. Of course, first you would use paint remover and a scraper for the easy stuff. For the engine and trans, it's dangerous to use a sand blaster. Hard to keep the engine sealed up, unless you are going to go for a complete rebuild of both, I would just paint strip, then wire wheel those.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Old Abe is Still Making Hay - by Jeremy Sweeten. Things have changed a bit since my last article. I am now almost finished graduate school at Purdue University. I am still in Agronomy, but specializing in hay and forages. My wife has survived two years of marriage to a part-time farmer. The equipment line up has changed a bit too. The DC has retired to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
